Jvc kw nt3hdt map update

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

·Map Update.Navigation/Multimedia Receiver – KW-NT3HDT – Introduction

 

KWNT3HDT Firmware UpdateNT3HDT Firmware UpdateNT3HDT Firmware Update 1. Preparation1. Preparation 1. Format the SD (or SDHC) card as FAT (Note – The card must be MB or larger.) 2. Extract the downloaded “zip file” to your computer desktop. 3. Copy the extracted file with folder onto the formatted SD card. (refer to Fig.1) Fig.1 4. Uniquement Pour Le KW-NT3HDT. Utilisation Du Service D’informations. Utilisation Du Service D’informations Routières. Utilisation Du Service D’informations De Zone (Service Total Traffic HD NET WORK) Vérification Des Informations Du Système De Navigation. Order your JVC North America Map Update – v.3 to benefit from the last GPS updates for your JVC North America Map Update – v.3 car. Upgrade your navigation system easily.

 

Jvc kw nt3hdt map update.Firmware Updates | JVC

KW-NT3HDT. Maximum Power Output. 50W x 4. Continuous Power Output (RMS) 20 + 20W RMS x 4ch at 4 ohms and no more than 1% THD*. MOS-FET Amplifier. Yes. Audio DAC. kHz/24bit. Order your JVC North America Map Update – v.3 to benefit from the last GPS updates for your JVC North America Map Update – v.3 car. Upgrade your navigation system easily. CD Receiver/ Digital Media Receiver Updates. Select a model name. English. AV Receiver Updates.
 
 
related:
Firmware Updates
KW-NT3HDT Software Version 1.0.024.1300
JVC Mobile Entertainment Car Navigation Updates
HERE Navigation System Product
·Unit Software
JVC North America Map Update – v.3 | Update your system | HERE
IDE to USB 2.0 and back

Some time ago, TheGadgeteer website published an article about a device that allows you to connect an IDE drive to a USB 2 port.0. Strictly speaking, such an adapter cable cannot be called a novelty, but it is of certain interest, so let’s get to know the Brando product better.

As you can see in the picture, the cable has a double-sided connector, which allows for the connection of 3.5- and 2.5-inch drives. Implemented support for USB 2.0 (speed up to 480 Mbps).

An external power supply is used to power the drives. It operates on an alternating voltage network of 100-240 V with a frequency of 50 or 60 Hz and provides two voltages at the output: 12 V (current power – 2 A) and 5 V (2 A). Thus, the power of the source is sufficient to power a hard disk drive or an optical disc reader and writer.

Since the connection uses a standard USB port, the product is compatible with IBM-compatible PCs and Apple computers. Device price – $ 35.

Source: TheGadgeteer

Leave a Reply

Your email address will not be published. Required fields are marked *